Thursday, December 08, 2011

mazda protege vent gauge pod

I have wanted to make this thing for a long time. I chose to make the gauge pod for the passenger vent. Once again, the gauge pod is made from PVC pipe. Well, at least part of it is. I used a piece of interior plastic to fill the hole where the vent stuff used to be. Then I molded the PVC pipe into the plastic. It's hard to tell but the gauge pod is angled. This time it took seven days to make.

Original installation December 2011

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.